J'ai vu cela :
http://www.opencockpits.com/uploads/manual_usbstepper_eng.pdfPage 7 : Il utilise un capteur avec trigger intégré, il y a 3 pattes GND, VO, et VCC
Mais bon avec une résistance de 10k a VCC ça doit fonctionner ?
Tu as vérifié la tension sur IN avec et sans cache ?
Page 6 : tu as vu qu'il faut 2 passes :
The card, to connect to the software, the first thing that does is to start turning the motor to pass up to 2 times the
optical sensor. Why 2 times?, Because the first it does is to put an internal counter to 0 and from this time begins to
count the number of steps you take to complete the second turn and pass a second time thorugh the optical sensor
and knows exactly the number of steps taken by the motor and also the time it takes to complete that lap.
Fabien